Chilipad Reservoir Extension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Addon extension to increase the size of the chilipad reservoir.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution
Here are two models to extend the chilipad reservoir.
chilipad_reservoir_ext_oring_v1
This model requires the use of an o-ring (78mm OD, 73.2mm ID, 2.4mm width). It is stretched to assemble, so a slightly larger OD/ID would likely be compatible. See link for what I used.
https://www.amazon.com/dp/B07HGBCGMV?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
chilipad_reservoir_ext_v1
Same model as above sans o-ring features. This would require some sealant to ensure the seam doesn't leak.
Printing:
0.4mm nozzle
0.2mm layer height
PLA+
4 walls minimum to prevent seeping through the layer lines
Wall Generator - “Arachne”
Supports - use normal (auto) and “snug”, add a brim to the bottom (inside and outer)
- Use a small screw driver to work into the o-ring channel, slide along the inside surface and slide, the supports should come out fairly easily.
Assembly
- Be sure to align the lid's locking tab's to the old container to ensure the lid is aligned and the handle is facing correctly when locked.
- I added a bit of silicone grease to the o-ring to help make the seal.
