Chilipad Reservoir Extension
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Addon extension to increase the size of the chilipad reservoir.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 32
- Makes
- 0
- Views
- 182
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution
Here are two models to extend the chilipad reservoir.
chilipad_reservoir_ext_oring_v1
This model requires the use of an o-ring (78mm OD, 73.2mm ID, 2.4mm width). It is stretched to assemble, so a slightly larger OD/ID would likely be compatible. See link for what I used.
https://www.amazon.com/dp/B07HGBCGMV?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
chilipad_reservoir_ext_v1
Same model as above sans o-ring features. This would require some sealant to ensure the seam doesn't leak.
Printing:
0.4mm nozzle
0.2mm layer height
PLA+
4 walls minimum to prevent seeping through the layer lines
Wall Generator - “Arachne”
Supports - use normal (auto) and “snug”, add a brim to the bottom (inside and outer)
- Use a small screw driver to work into the o-ring channel, slide along the inside surface and slide, the supports should come out fairly easily.
Assembly
- Be sure to align the lid's locking tab's to the old container to ensure the lid is aligned and the handle is facing correctly when locked.
- I added a bit of silicone grease to the o-ring to help make the seal.
