1 / 2
Weighted two-part wire spool for antenna radials
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a spool for holding wire radials for a portable antenna. I wanted it to have some weight to it so that you could unspool it and lay it on the ground and be sure it doesn't coil back up.
There's a 2mm hole for inserting the end of the wire to hold it when it's fully unspooled.
This is a two part spool, so print two copies of this item with the large part flat on the bed and there will be no need for supports.
The weights I used were 1 ounce adhesive wheel weights available on Amazon. Put three of them into the slots provided and then glue it together.