1 / 2
Weighted two-part wire spool for antenna radials
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A weighted spool for antenna radials
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 174
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a spool for holding wire radials for a portable antenna. I wanted it to have some weight to it so that you could unspool it and lay it on the ground and be sure it doesn't coil back up.
There's a 2mm hole for inserting the end of the wire to hold it when it's fully unspooled.
This is a two part spool, so print two copies of this item with the large part flat on the bed and there will be no need for supports.
The weights I used were 1 ounce adhesive wheel weights available on Amazon. Put three of them into the slots provided and then glue it together.