FlashForge AD5x purge bucket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Another purge bucket for the AD5X.
- Ocena
- 4,5 / 5
- Polubienia
- 43
- Pobrania
- 587
- Wydruki
- 0
- Wyświetlenia
- 3282
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Lots of buckets out there, but I wanted something easy to print, hold a lot of purge, not block the psu venting and easy to grab to dump.
Handle needs heated inserts M3 5mm OD x5mm length. M3x6mm screws. The other option is to just drill out the holes in the bucket and use screws and nuts.
There is a built in support with .3mm spacing. So you can print this up to .30 layer height and still should be able to release the support.
I printed it on the AD5x default PLA .24 profile.
-I updated the bin to have the option of adding 3 magnets on the front lip to keep the bin up against the printer. My test print was press fit, but glue may or not be needed to hold the magnets in.
Hardware :
- 2 x M3x5mm OD x 4mm L heated Inserts
- 2x M3x6mm screw
Handle Option with no heated inserts:
- 2x m3x10mm screws nuts and washers . Screw through the bucket wall. its only 1mm thick behind the heatset hole.
Added Magnet Option:
- 3x 6mm diameter x 3mm thick magnets