Adler 87 Bobbin, dimension 24 x 8.5mm and 6mm hole
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adler 87 Bobbin, dimension 24 x 8.5mm and 6mm hole
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
Replacement bobbin for my Adler 87 Sewing machine, dimension 24 x 8.5mm and 6mm hole
Such a bobbin is hard to print in one piece, possible with a Resin-Printer.
The main focus for this model was to get it as accurate as possible, and easy to print with an FDM printer. Both half-pipes are equipped with a 1mm hole to insert the end of the thread before winding the bobbin.
If the holes are not printed fine, simply use a Dremel or small drill
Printed with PETG, 100% infill, on my Prusa MK3s, 0,15mm layer and a 0,4mm nozzle
I am sure you get much better results with a 0,25mm nozzle and smaller layer.
Will give it a try when I own such type.
Additionally I designed a small tool. Makes it easier to assemble the two halfpipes into the bobbin-side.
Depending your printer it is possible required to rescale in your slicer to get it in perfect dimension