Duplicator 4 OHSH OverHead Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed from http://www.thingiverse.com/thing:12974 as the Dup4 is close to the Replicator 1 but it varies enough to…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
Remixed from http://www.thingiverse.com/thing:12974 as the Dup4 is close to the Replicator 1 but it varies enough to require a slight rework.
Revision 2 allows for easier attachment and better fitment with the added relief.
Removed older version and added new Sketchup source file. Also ran the file through Netfabb prior to uploading.
Instructions
Print 2 of these Grab the top piece from here... http://www.thingiverse.com/thing:12974/#files (YAFSH_Top.STL) and print 2 of these as well.
If you need a smaller diameter spool holder, you can check out my recently published spool holder top.. http://www.thingiverse.com/thing:190805
Assemble carefully (notating proper position) and tap together with a mallet or some other tool for whacking. I say this because I put one together with the top facing outward...took a good 20 minutes to separate the two pieces without damaging.
Thanks @mikefrisina for the simple, elegant design.
Category: 3D Printer Accessories