Bambu P1S Extraction Mount and Connectors for 50mm Ducting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Extraction mount system to make linkup and disconnecting your P1S from your ducting Waaayyyy easier than alternatives.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 374
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution
It's an extraction mounting system which makes connecting and disconnecting your Bambu P1S from your ducting Waaayyyy easier than screw and magnet fitted alternatives.
Got your printer sat on a shelf or worktop and the air extraction vent mounted on the rear where you cannot see and struggle to reach to disconnect from extraction, then this is your solution. Printer maintenance becomes more like a battle when you're stuck firstly trying to get a bad extraction connector off your printer.
This is super simple no screw, clamps, or latch functions to operate or worry about. Just pull and away you go, you’ve disconnected your printer from your fancy new ducting system to do your maintenance your printer needs with far less hassle and wasted time.
Made to work with 50mm ducting. Also included is the connectors I designed and printed for my dual P1S setup which included 50mm ducting connectors and adaptors for going 50mm to 100mm ducting.
Please Download and read the PDF “READ ME” file below under the “Other Files" tab. It'll provide some guidance on the printing and primarily the fitting of the extraction mount.