PSU Bracket for Voron V0.2 (R1)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screw in PSU bracket for the Meanwell LRS-150. No VHB tape required.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 66
- Wydruki
- 1
- Wyświetlenia
- 383
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Screw in PSU bracket for the Voron V0.2 to alleviate the need for VHB tape. Screws in to the bottom of the front and rear extrusion. You will need to preload the nuts during frame assembly, or disassemble to mount it.
Assuming no other mods there should be a total of 6 preloaded nuts on the underside of the front extrusion and 4 preloaded nuts on the underside of the rear extrusion. This mod is compatible with No Drop Nuts.
This is ONLY compatible if you are using the front display on the V0. It will NOT work if you are using the headless middle skirt.
You will need to use supports on the 2 mounting tabs.
Bom:
3x M3 6mm Screws For Psu Mounting
4x M3 8mm Screws for Bracket Mounting
1x M3x5x4 Heat Insert (Voron Spec)
4x Preloaded Nuts (Compatible with NDN)