DJI Avata 2 up and down GoPro style mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Attach a camera or other accessory to the bottom or top of the Avata 2
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 424
- Wydruki
- 1
- Wyświetlenia
- 1444
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I modified the original mount by removing the part with the 1/4" thread and added GoPro-style mounts on both the top and bottom of the Avata 2. I also made a small clip that fits into the unused GoPro-style mount, allowing you to use either the bottom mount, the top mount, or both at the same time—if the drone can handle the weight.
Why this type of mount instead of a standard 1/4" thread? Because you don’t always have access to tripod threads or the right screws, while a GoPro-style mount is much more convenient—you just need a basic M5 bolt and a nut. Ideally, use the original GoPro thumb screw with an M5 nut, or a standard M5x20 screw with an M5 nut.
I’ve used the top mount to attach an Osmo Action 2 to capture footage in front of the drone, and now I’m working on installing an additional gimbal underneath the Avata 2.
Recommended 3D printing settings:
Material: PETG or ABS/ASA
Layer height: 0.2 mm
Nozzle diameter: 0.4 mm
Wall line count: 6
Infill: 25%
Supports: Tree-style, build plate only