SV08 BTT Manta M8P Mount & Cooling Mod Kit

This kit allows you to install the BTT Manta M8P motherboard into the SV08 3D printer using a precision-designed mounting bracket and cooling shield system. The red IO template helps mark and cut the existing "milk tray" (see attached pictures—the red part is the template) to fit the new IO shield while keeping the original side hole for clean cable management.

The bottom cooling shield includes mounting for either two or three 5010 GDS Time fans—one for the MCU, one for stepper drivers, and an optional one for SSR and PSU cooling. The Manta bracket uses 2 T-nuts in the aluminum extrusion and one of the original motherboard screw holes.

The shields use the original mounting holes. Be careful—these holes are plastic and can be easily damaged (ask me how I know!). If they break, you can secure things with hot glue as a backup.

I haven’t installed the Manta on my unit yet, but I’ve tested the shields and the mount. Everything should fit perfectly since the CAD is 100% accurate.

📦 Bill of Materia.ls (BOM):

For Manta M8P Mount:

1x BTT Manta M8P 👉 Affiliate Link http://shrsl.com/4vxd1 

2x M3x8 screws + T-nuts (frame side)

1x M3x8 screw (original board mount hole)

4x M3 heat set inserts (4.5mm height, 4mm OD)

4x M3x6 screws (to mount the board)

For Cooling Shields:

2–3x 5010 24V fans  I like to use GDS TIME fans https://s.click.aliexpress.com/e/_olGlBXX  since they are low noise and work great on PWM

8–12x M3x14 screws (4 per fan)

8–12x M3 nuts (4 per fan)

Optional:

Hot glue (to secure the shield if the original mounts get damaged)