Angle cube holder for Work Sharp Precision Adjust
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A little attachment that can be put on the handle of the Work Sharp Precision Adjust abrasives. It allows to attach a…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 434
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
A little attachment that can be put on the handle of the Work Sharp Precision Adjust abrasives. It allows to attach a angle cube or similar tool to be magnetically attached for hassle free and hands free angle adjustments.
Attention: After printing check that it fits perfectly. there should only be some play to slide up/down ca 0.5mm as this short wiggle helps to seat it flush against the handle.
I used M4 washers with an outside diameter of 12mm and glued them in with superglue. Make sure they don't protrude above the surface. From what I could find online a #8 SAE washer should be about the same size.
For a smooth top layer I enabled the ironing function of my slicer but it should be fine without that or a quick (slight!) sanding.
Print Settings
Printer:
prusa mini+
Supports:
No
0.2mm
Infill:
15%
Category: Parts