1 / 4
Škoda Fabia Trunk Tenon Sleeve Fix — zdjęcie 1
1 / 4

Škoda Fabia Trunk Tenon Sleeve Fix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Orientacyjna cena wydruku pliku

0,22 € – 0,27 € netto (bez VAT)

Dla pliku: SkodaFabia_dekl_34m_0,08mm_200C_PLA_ENDER3V2.gcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 0,24 € netto (środek widełek).

Masa podana przez autora
1 g
Czas druku podany przez autora
20,4 min
Materiał u źródła
PLA
Materiał wyceny
PLA
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

This sleeve eliminates the annoying sounds coming from the trunk area on some newer Škoda models e.g., 2024 Škoda Fabia

Ocena
0 / 5
Polubienia
5
Pobrania
23
Wydruki
0
Wyświetlenia
294
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Public Domain

Fix for Škoda Rear Trunk Cover Noise

On many new Škoda models, the rear trunk cover makes rattling noises when driving over bumps. This is caused by excessive tolerance on the two tenons. An official Škoda dealership "fixed" it by wrapping electrical tape around the tenons, but of course, the tape eventually peeled off.

This 3D-printed sleeve is a proper solution. It slips over the tenon to tighten the fit and eliminate the noise.

Printed in PLA with the smallest layer height (you can use taller layers to speed up the print if needed).

For best results: use a scarf joint and aligned seam position.

If the seam is still noticeable, a bit of sanding will clean it up.

Tagi