Hamilton X-Wind stuck bezel tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vice that allows to un-stick bezel on X-wind watches.If a bezel doesn't move try to apply penetrating oil (rust…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Vice that allows to un-stick bezel on X-wind watches. If a bezel doesn't move try to apply penetrating oil (rust removing etc) to the bezel edge and leave it for few hours or more then you can use the vice to give it a push.
It's printed to be a bit tight so you have to pull handles apart a bit insert it over the bezel aligning bumps with the notches and try rotate it without even squeezing the handles if it slips try to gently squeeze the handle and slightly rotate it back and forth before applying more force. It should be easy if it's too hard apply penetrating oil again and wait even longer as forcing it might break stuff.
Use with caution.
Once it moves clean out the edges and apply more oil and rotate the bezel to remove as much gunk as possible.
Print with at least 4 walls with 0,4mm nozzle. PLA works fine. Avoid any abrasive filaments so no CF or GF infused filaments as it may leave marks on the case or the bezel.
Category: Hand Tools