Electrolux Hygienic 800 - Oval to Round Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a round adapter for the Electrolux Hygienic 800 vacuum cleaner, which normally uses an oval connection.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 174
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
This is an adapter for the Electrolux Hygienic 800 vacuum cleaner, which normally uses an oval connection. Sometimes a round pipe is more practical, so I designed this adapter to allow that. The round part outer diameter is ⌀ 35 mm.
Special feature: inside the adapter, there's a built-in nut holder for an M3 screw. If your printed part doesn’t fit tightly, you can insert a nut and screw to secure the connection firmly.
This is a working prototype that has performed well for me.
I printed it on a Prusa Mini+ using PrusaSlicer.
Note: due to typical slight shrinkage during printing, the inner holes turned out a bit smaller than in the 3D model, making a very tight connection to the vacuum cleaner — but it still works fine.
I may update the design in the future based on further testing.
Printing recommendations:
Printer: Prusa Mini+
Slicer: PrusaSlicer
Supports: Not needed
Layer height: 0.2 mm recommended
Material: PLA or PETG