Nail Dust Collector / Solder Fume Extractor Hose Fastener
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Locking adapter for nail dust collector used as a fume extractor
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 574
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
I found this device on AliExpress and it was labeled as a solder fume extractor. A real fume extractor should probably have an activated carbon filter though. I later discovered this device is actually meant for nail salons to collect nail dust. Regardless, I was mostly happy with my purchase.
One issue I did notice though was that the flexible hose doesn't fit snug into it's opening. I was expecting it to lock-in-place. I designed this part so that you can twist and lock it into the 3 openings on it's non-LED face, then the flexible legs create a holding force from the inside of the housing.
I recommend that you cut this print in half in your slicer and then use super (cyanoacrylate) glue the two pieces together. Cut along the diameter so that you have two rings: one ring with the 3 locking hooks, and one ring with the 4 legs. See screenshot for a demonstration.
For my personal print settings:
- 0.16mm layer height
- 5 perimeters
- 30% gyroid infill
- I printed without supports or brim
- Microcenter (eSun) PLA+ at 215C and the bed at 50C
- Printed on a modified Creality Ender 3v2 with Klipper
I recommend you also check out this other design by Derek Smoriga: https://www.printables.com/model/625315-60w-solder-fume-extractor