1 / 5
KTM 2 stroke fan shroud for Emperor radiator braces — zdjęcie 1
1 / 5

KTM 2 stroke fan shroud for Emperor radiator braces

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a custom fan shroud to fit 2016 KTM two strokes with Emperor racing radiator braces

Ocena
0 / 5
Polubienia
2
Pobrania
19
Wydruki
0
Wyświetlenia
286
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

I have a 2016 ktm 300xc and needed a radiator fan. The standard one that uses the Spal 30103018 does not fit on my Emperor radiator braces as it's too big.  (https://www.emperorracing.com/product/radiator-frame-1803/)

I found a smaller DC radiator fan that's IP69k rated and circa 50w that pulls a LOT of air, it's a SUNON PF80381BX-1000U-A9H. It's available from Digikey, newark and mouser.

I wired this into the stock radiator power plug with the ground switched through a fan temp switch for an older BMW (Beck/Arnley #201-1310), that switches the fan on at 95c and off at 90c.

This is the shroud to mount the fan to the radiator braces. It works extremely well and is very secure with the 4 zip ties.

4mm brass inserts are used for the fan mounting. I printed it in CF-Polycarbonate, PA6-CF would be better but that's what I had. A rigid TPU would also work, it can easily stand 100c.

Update; I burned out the Beck/Arnley switch as the fan current was too high; I have wired in a solid state relay, a miniature 4 pin relay from NAPA.

Tagi