Creality K2 Plus waste Chute -Heat Recirc Mod Compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a quick waste chute that I drew up to work with the Chamber Heat Recirc Duct installed.
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 125
- Wydruki
- 2
- Wyświetlenia
- 1096
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple waste chute designed around the Creality K2 Plus Chamber Heater Recirc Mod made by zemlin. https://www.printables.com/model/1193116-creality-k2-plus-chamber-heater-recirc-mod The mod by zemlin has worked amazing and I hope this helps anyone who still needs their printer as close to the wall as possible. This was printed out in a glossy PETG and I glued in (6) 3mm x 8mm magnets to hold it tight against the back of the K2. I think I used .20 layer height. It can be printed flat on its bottom (the sides of the chute both pointing up). The magnets make it easy to pivot the slide up and down to remove a waste bin that is sitting on the same flat surface as the printer itself. The screw just helps keep things aligned with the waste chute so you don't end up with a bunch of purge balls piled up behind your printer.