Adjustable motor mount for Wltoys 124008/124010
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Using the original 36XX/5X0 motor mount the gear mesh seemed a little too tight, so I made this adjustable one.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 240
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Summary:
Using the original 36XX/5X0 motor mount the gear mesh seemed a little to tight, so I made this adjustable one.
It is printed in two halfs to remove the need for supports. The halfs are screwed together with two M2x6mm FHCS. On the bottom the motor is held by a M3x8mm FHCS and the top hole uses a M3x6mm SHCS. Depending on the depth of you motor holes you could use longer screws.
The outer part needs to be 3.1mm tall, so I recommend a layer height of 0.1, two walls and 100% infill. The filament of choice should be able to take the heat of the motor. I used ASA and PA while testing.
Hardware:
| Part | Size | Qty |
| Flat head cap screw | M2x6mm | 2 |
| M3x8mm | 1 | |
| Socket head cap screw | M3x6mm | 1 |
"Happy printing, and God bless, my friend."
— Bob Ross