Fractal Ridge Fan Duct for ID-COOLING IS-67-XT 120mm CPU cooler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fan duct to fit the IS-67-XT in a Fractal Ridge
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 583
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Updated model by scaling size to 120mm L&W, replaced holes with slots, and sliced off the excess to 5-6mm height.
The 6mm height is what I'm using now and fits well/tight against the side panel. 5mm was the original size but the sides can bend upwards letting air escape. The 6mm is much stiffer.
I've included the scaled version without the top cutoff in case it may be of use for other applications.
Edit 5-10-25: The 6mm still has a little gap between the secure points. To obtain a better seal, I've used a piece of black Sugru (moldable silicon putty that cures). Using scissors, cut into four even strips lengthwise. Using hands, roll into a snake about 50-100% longer than original length. Secure them onto the perimeter of the bracket (the corners do not need them) using your fingers then secure the bracket using the screws. Use your fingers to smooth out any that squeeze out and make sure all cracks are blocked and nothing is in the way of the fan.