1 / 2
Fractal Ridge Fan Duct for ID-COOLING IS-67-XT 120mm CPU cooler — image 1
1 / 2

Fractal Ridge Fan Duct for ID-COOLING IS-67-XT 120mm CPU cooler

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fan duct to fit the IS-67-XT in a Fractal Ridge

Rating
0 / 5
Likes
3
Downloads
42
Makes
0
Views
583
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Updated model by scaling size to 120mm L&W, replaced holes with slots, and sliced off the excess to 5-6mm height.

The 6mm height is what I'm using now and fits well/tight against the side panel.  5mm was the original size but the sides can bend upwards letting air escape.  The 6mm is much stiffer.

I've included the scaled version without the top cutoff in case it may be of use for other applications.

Edit 5-10-25: The 6mm still has a little gap between the secure points.  To obtain a better seal, I've used a piece of black Sugru (moldable silicon putty that cures).  Using scissors, cut into four even strips lengthwise.  Using hands, roll into a snake about 50-100% longer than original length.  Secure them onto the perimeter of the bracket (the corners do not need them) using your fingers then secure the bracket using the screws.  Use your fingers to smooth out any that squeeze out and make sure all cracks are blocked and nothing is in the way of the fan.

Tags