Approve / Reject Stamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Y-junction stamp design that has two stamp faces...one for a positive check mark, one for a negative X mark.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 109
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Pivot this rubber stamp side-to-side to alternate between approve and reject.
Print this Approve / Reject Stamp using a FLEX material. The stamp shown in the photos was printed using Matterhackers Grey TPU. The settings are shown in the .3mf file.
**Prints nicely on a Textured plate without glue since the stamp face is not on the build plate.
**A light, 5 to 10 minute sanding of the stamp face works well.
Settings:
1.) 0.20 mm (Structural) layers
2.) Generic FLEX
3.) 15% Infill
4.) Orient with stamp faces directed upwards (away) from build plate
5.) No supports
See my other Stamps & Seals contest entries here.
Enjoy!