AeroPress Coffee Scoop / Spoon Holder for Ikea Skadis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder for the scoop that comes with AeroPress coffee makers for IKEA SKÅDIS pegboards
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 253
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This is a holder for the scoop that comes with AeroPress coffee makers for IKEA SKÅDIS pegboards. It works with both the older version of the scoop and the newer version with the dimples on the handle.
It uses Skadis T-Nuts for a secure and rattle-free hold.
![]() | Read more about the Skadis T-Nuts Mounting System and check out the Skadis T-Nuts Collection for more Skadis accessories that use T-Nuts. |

Required Hardware
| Qty | Description | Sourcing |
|---|---|---|
| 1 | M2.5 DIN934 Hex Nut | Aliexpress |
| 1 | M2.5 x 12mm Socket Head Cap Screw | Aliexpress |
Printed Parts
| Qty | Part | Download |
|---|---|---|
| 1 | Skadis AeroPress Scoop Holder | this project |
| 1 | Skadis T-Nut M2.5 | Download here |
Printing
Print the part in the original orientation. The STL file has been pre-rotated into the right orientation for printing.
Recommended Settings
The part has steep overhangs in the front. If your printer doesn't have the best cooling I'd recommend printing it a bit slower to get a nicer surface finish in that area.
- Material: PLA, PETG, ABS, etc.
- Layer height: 0.2mm
- Extrusion width: 0.4mm or 0.45mm
- Perimeters: 3
- Infill: 15%
- Supports: no
Assembly & Installation
Step 1: Prepare T-Nut
Insert the hex nuts into the bottom of the T-Nut. The nut should fit tightly and not fall out. Use superglue if the fit is loose and be careful to not get any glue onto the threads.

Step 2: Install T-Nut
Push the M2.5 screw all the way into the screw hole all the way and screw on the T-Nut until there's a gap of about 2mm between the T-Nut and the Holder.

Step 3: Installation
Orient the T-Nut vertically and then push the whole assembly through the hole in the desired location on your pegboard. Center the T-Nut in the hole. You can feel how the Alignment Guide at the back naturally falls into the pegboard hole.
While maintaining some light pressure on the screwdriver, tighten the screw firmly but do not over-tighten. As you tighten, the T-Nut will lock in the horizontal orientation.

Ready to Use

Removal
To remove the holder, loosen the screw by one or two turns and pull it out.
Bonus
A fairly accurate 3D model of the AeroPress scoop in STEP format is included in the Files section for people who want to use it to design their own holders or use it in mock-ups.

Additional Credits
This design was inspired by the Aeropress scoop holder by Moe Skitoe.
