Nerf Flywheel Puller 3m Version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Building Toys
- Licencja
- Creative Commons — Public Domain
Used for pulling nerf flywheels that have been over pressed.
(Unpopular opinion): I prefer to over press and then use this to work upwards and fine tune alignment especially with two stage setups, utilizing a very long hex key to really dial it in.
Needs a 3m nut and screw
Tested with Daybreak and Kepler flywheels and works very well and clicks slightly in place.
Recommend using a lighter color filament as well as using the viewing to ensure the screw is against the shank instead of the plastic. I struggled with this before adding the windows.
Print on its back “open slot up for layer strength” was great advice.
Hope it works, I did very little work on this so the real credit goes to Kellysparky and original designers.
-Ned