Nerf Flywheel Puller 3m Version
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Needed a flywheel puller but only had 3m screws.
- Rating
- 4.5 / 5
- Likes
- 23
- Downloads
- 98
- Makes
- 2
- Views
- 446
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Building Toys
- License
- Creative Commons — Public Domain
Used for pulling nerf flywheels that have been over pressed.
(Unpopular opinion): I prefer to over press and then use this to work upwards and fine tune alignment especially with two stage setups, utilizing a very long hex key to really dial it in.
Needs a 3m nut and screw
Tested with Daybreak and Kepler flywheels and works very well and clicks slightly in place.
Recommend using a lighter color filament as well as using the viewing to ensure the screw is against the shank instead of the plastic. I struggled with this before adding the windows.
Print on its back “open slot up for layer strength” was great advice.
Hope it works, I did very little work on this so the real credit goes to Kellysparky and original designers.
-Ned