1 / 1
24mm Arcade Button Hole Plug + Wrench
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Used to plug unused button holes.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 158
- Wydruki
- 1
- Wyświetlenia
- 611
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (16)Powiązane
Introduction
This is a substitute for an arcade button. I purposely design some of my arcade stick enclosures with too many button holes – for more options. I use these to fill any empty 24mm holes. I designed them to be quite robust, so they can take a good amount of torque.
I've only used this plugs on my CHAMELEON panels, which are ~3mm thick at the install area. But, I think they should accommodate up to a 6mm thick panel.
It comes with 3 parts: a plug, a ring, and a wrench.
Future Changes
- May make a 30mm version – if there is a demand for it.
- May make a slightly longer version for thicker panels.
Printing Suggestions
- 4 Walls / 20% Cubic Infill / No Supports
- Orientation should be self-explanatory – all flat faces towards the build plate.
- Only tested in PLA/PLA+, but other materials should work.
- Recommend scaling the X and Y axes to 101% in your slicer for the RING for an easier fit. Not entirely necessary though, if your printer is accurate enough.
- You may need to make adjustments based on the tolerances of your printer
Assembly
- Insert the PLUG into the hole.
- Screw the RING around the threading of the PLUG.
- Fully tighten with the WRENCH.
Happy Printing!
RAF