1 / 3
K1 Max with CFS Upgrade rear riser segment
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A modified rear riser segment to allow the lid to be used with the CFS Upgade
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 273
- Wydruki
- 0
- Wyświetlenia
- 2082
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 2)Remiksy (0)Kolekcje (33)Powiązane
I rotated the object 45 degrees so that it fits onto the K1 Max print bed easily. I also enabled auto tree supports just to make sure the holes didn't have issues since I didn't want it squishing the PTFE to introduce friction.
You may need to reuse some of the old tube that was in use before the upgrade. Steps to use:
- Print and install the riser, I like to add some adhesive backed foam around the top for the glass to sit on, but thats optional.
- Install the PTFE coupler onto the back of the riser using the provided M3 scew that is securing it after upgrade.
- Feed a tube of the right length from the coupler through the hole and into the extruder, add some of the previous PTFE clips to secure it to the cable chain, I ended up using the old tube that was used before the upgrade, I guessed at the length, I just made sure there were no tight bends. (See cover photo)
- Connect the CFS buffer to the coupler using a length of PTFE long enough to have a nice wide radius. You may need to move the CFS buffer to another spot on the back of the K1 Max. (See photo 3)
- Test it all.
Note: This works for me, this is a do it at your own risk, if it breaks, I can't help you, and I doubt creality will help you..