1 / 2
Wall Holder for Hewlett Packard ZBook 15 Mobile Workstation — zdjęcie 1
1 / 2

Wall Holder for Hewlett Packard ZBook 15 Mobile Workstation

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I wanted my work notebook off my desk for space and noise reasons, so I designed this wall holder.

Ocena
0 / 5
Polubienia
4
Pobrania
45
Wydruki
0
Wyświetlenia
569
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

I wanted my work notebook off my desk for space and noise reasons, so I designed this wall holder. Hole spacing is 60 mm, a 4 mm Philips flat head wood screw will fit. I designed this for a pretty hefty 15 inch mobile workstation, so most any notebook should fit. You need to adjust the spacing of the two pieces to your requirements of course.

I printed this in PETG 0.2 mm resolution. The slight angle away from the wall is intentional so that the hot air exhausted out the bottom of the notebook can escape better, also easier to drop it into the slot.

Print instructions

Category: Computer Print Settings

Printer Brand: Prusa

Printer: I3 MK3S

Rafts: No

Supports: No

Resolution: 0.2 mm

Infill: 20%

Filament: Prusament PETG black
Notes:

If you look at the picture "print orientation", this is how the part is intended to be printed. This requires no support structures.

Tagi