1 / 3
Wyze Cam Pan V3 front door mount for Qidi Plus4 — zdjęcie 1
1 / 3

Wyze Cam Pan V3 front door mount for Qidi Plus4

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Wyze Cam Pan V3 front glass door mount for Bambu P1S/X1C modified to work on a Qidi Plus4

Ocena
0 / 5
Polubienia
4
Pobrania
14
Wydruki
0
Wyświetlenia
192
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Made a slight adaptation to the original model to allow it to mount to the front glass of the Qidi Plus4. The original screws are a little tight so I suggest threading them through the mount first and make sure to seat them all the way to the bottom before mounting. I also apply a thin strip of 3M VHB tape near the bottom of the drop leg but leave the backing on to act as a dampener against the glass.  As you can see the door does open to at least 90 degrees but is slightly more limited over stock due to the thickness of the upper mount.  I have printed in both PETG and PLA and both seem to hold up fine. PETG may be a better option in the long run with the heated chamber of the Qidi Tech printer. This remix was done by cutting and splicing in Bambu Studio so don't expect fusion 360 quality aside from the original model.

Tagi