Metolius Superclip Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter from Metolius Superclip to Mammut Short probe.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 100
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Im tired of printing clipsticks for climbing and ending up with fatigue fractures in my parts. The last one i printed was in PETG, and that did not work with the part flexing on a small piece of the print over several cycles, so i bought the Metolius Superclip and spent way more time than i should have learning SolidWorks to make a adapter from the Superclip to my avalanche probe.
For this model to work you need to cut off the tip of your avalanche probe. Might revisit this model if anyone wants an adapter with the probe intact. I think i will add a hole for a setscrew so there is no need to glue or tape the probe to the adapter. Also might add a way to “click” the adapter to the Superclip.
This print is meant for the Mammut Short probe (240cm), or a pole with external diameter of 11.25mm.
I glued the Superclip to the model and the probe to make sure it doesn’t come loose or unthread.
- Infill: 25%
- Material: PETG
- Walls: 4
- Infill type: Gyroid adaptive
- Support: Printbed only
Infill is probably overkill but i want to be sure it holds up.
Happy Climbing!