1 / 2
RadioMaster Pocket: Minimalist Lanyard Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Attach any 25mm lanyard strap directly to your RadioMaster Pocket.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 67
- Wydruki
- 0
- Wyświetlenia
- 899
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (26)Powiązane
The clippy buckle thing on my NewBeeDrone lanyard was too big, so I removed it entirely and made this so I could use it. Integrates the lanyard more directly into the radio, in my mind.
Probably works best with lanyards with quick-release buckles!
You will need:
- 1x M2 8mm.
- 1x M2 20-25mm
Then:
- Print both sides flat out of PETG or similar. Add a little bit of support for the lanyard “rod” only. ~0.2mm, 4 wall loops, and 100% infill recommended.
- Fit each part through your lanyard first so that they just about meet up.
- Rotate into place where the radio's lanyard holder is. Might need a bit of pushing and clicking to get everything to “snap” into place.
- Secure the clip with the two screws.