1 / 2
RadioMaster Pocket: Minimalist Lanyard Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Attach any 25mm lanyard strap directly to your RadioMaster Pocket.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 67
- Makes
- 0
- Views
- 899
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The clippy buckle thing on my NewBeeDrone lanyard was too big, so I removed it entirely and made this so I could use it. Integrates the lanyard more directly into the radio, in my mind.
Probably works best with lanyards with quick-release buckles!
You will need:
- 1x M2 8mm.
- 1x M2 20-25mm
Then:
- Print both sides flat out of PETG or similar. Add a little bit of support for the lanyard “rod” only. ~0.2mm, 4 wall loops, and 100% infill recommended.
- Fit each part through your lanyard first so that they just about meet up.
- Rotate into place where the radio's lanyard holder is. Might need a bit of pushing and clicking to get everything to “snap” into place.
- Secure the clip with the two screws.