Kolver FAB12 RE Electric Torque Screwdriver Housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The housing rotted on my Kolver screwdriver so I modeled it with the same design for replacement.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a nearly exact replica of the housing for the Kolver FAB12 RE screwdriver I got with some stuff I purchased. For some reason the plastic on the original basically rotted out and became extremely brittle. It was basically disintegrating in my hands.
I didn't even bother looking to see if they still sold this housing as what's the point of having a 3d printer if you can't make your own replacement parts. It was a bit of a challenge to get everything modeled more or less the same as the original but I was able to get it working and fitting pretty well.
Simply disassemble your old one and reassemble using the original screws. I did end up adding an extra screw near the connector for added strength however it is not necessary with the metal D ring that the screwdriver hangs from and inserts into the holes on the top sides. If you would like to use the screw you will need a M2 or M2.2 x 8mm plastic threading screw similar to the original 12mm screws.
I reused the original switch however I modeled it as well in case you need it.
I printed mine in Polymaker Jet Black ASA and it came out beautifully. I tried ASA CF at first but I find it to be a little more brittle and it split when screwing it together. PETG would also work well.
Printed in 0.2mm layers, 3 walls, 25% gyroid infill, outer and inner brim, hybrid tree supports @ 30degrees (make sure to force support at the overhang at the top where the GX16-5 power connector sits).