Emoji Stamp Inserts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Inserts (for my Swappable Stamp model) with emoji symbols
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 55
- Wydruki
- 1
- Wyświetlenia
- 166
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
These inserts are made to be used with my Swappable Stamp model
Printing information:
Use a flexible material like TPU
Print in the same orientation as the insert came (on its flat round base)
No supports are needed
Ironing (with the 3d printer) the highest surface will improve the finish of the stamp and will therefore improve the stamped results, alternatively you can also sand the model down with a high grid sandpaper (220p works well) afterwards.
Note that would you wish to make your own insert, check out the blank insert in the base model that was made for this purpose.
---
To store the insert packs for the Swappable Stamp (like this one), I made this storage solution:
https://www.printables.com/model/1543876-swappable-stamp-storage-tubes-fusion360
As this pack contains 5 inserts, you will need the ss_insert_storage_5 in the "Inserts only tubes" directory.
---
For more info about the stamp please check out the base model.
All the emoji svgs come from svgrepo, the faces were made by thewolfkit and the thumbs up is from primefaces (https://www.svgrepo.com/svg/506603/thumbs-up-fill)