Camera hot shoe adapter base / cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Camera hot shoe cover, or use as a base for building something else to mount on a camera.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 108
- Wydruki
- 1
- Wyświetlenia
- 577
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
This is intended to be used as a base for building something else to mount on a camera hot shoe. As is, it serves as a hot shoe cover (which comes with the camera but is among the first things lost because the part is so small).
The front end of the adapter base is beveled for easier insertion. Printing at 0.25mm layer height makes all the heights in the design accurate, resulting in a snug fit even without the friction clips on the sides.
The dimensions are based on my measurements taken from a Nikon D5100 DSLR camera.
The OpenSCAD model creates a mount with the 12mm wide x 16.4mm long pedestal centered at [0,0,0], on which you can design something to mount on it using OpenSCAD. I plan to use this as the base for a flashlight mount. The pedestal is adjustable in height with one parameter.
Print Settings
Printer Brand: Prusa
Printer: I3 MK3S
Supports: No
Resolution: 0.25mm layer height, 0.4mm nozzle
Infill: 15% gyroid
Filament: Generic PLA
Notes:
The only print setting to be concerned with is the layer height. Printing at 0.25mm height gives the most accurate thicknesses for this piece. Tolerances are tight so this is important.
With PrusaSlicer, you can do this by going to Adaptive Layer Height and using a quality/speed setting of 0.5. Then it automatically sets the layer height to 0.25.
Category: Camera