Expanded Hollow-point Round Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you shot a hollow-point bullet so that it expands but is somehow still in the brass, then it might look like this
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 227
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
I was asked for a stand for an antenna at 11" high that looked like an expanded hollow-point bullet and this is my novice attempt. Not modeled after any specific round.
Print it either single or multi; not sure which wastes more filament: double supports or a small wipe tower. But if you go single then you'll need to glue the lead part onto the copper part. You also probably want a brim around the tips of the ‘petals’ on the lead/copper parts.
The two brass parts are large enough that they're great models to use adaptive/support cubic infill. No need for supports on the brass. The inner threads didn't print particularly well for me but as long as you remove the bad/excess strands then it should be fine.
Looks a lot like a palm tree tbh