25W Magsafe charger clamp for IKEA UTVISNING
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Orientacyjna cena wydruku pliku
2,00 € – 2,45 € netto (bez VAT)
Dla pliku: 25W Magsafe charger clamp for IKEA UTVISNING_v2_0.2mm_PLA_MK3S_2h10m.gcode
To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.
Plik i założenia wyceny
Plik użyty do wyceny
Średnia wycena orientacyjna: 2,23 € netto (środek widełek).
- Masa podana przez autora
- 29 g
- Czas druku podany przez autora
- 2,17 godz.
- Materiał u źródła
- PLA
- Materiał wyceny
- PLA
- Drukarka wyceny
- Bambu Lab P1S - 0.4 nozzle
- Proces wyceny
- 0.20mm Standard
Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.
Zapisane na tym urządzeniu.
Magsafe charger clamp remix to fit monitor shelf from IKEA UTVISNING. Suitable size for new Apple 25W MagSafe charger.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 625
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I remixed it to fit the monitor shelf of my IKEA UTVISNING desk.
The monitor shelf is about 22.3mm thick and the remixed model has a gap of 22.2mm.
I removed the screws from the model because it fits the shelf very well.
This remixed model is made with a holder that fits the size of the Apple 25W MagSafe Charger (A2580&A3250).
The fit isn't too tight for installation, but it's tight enough that the magnets won't come out when I place or remove my iPhone.
Support is not required, but adding a brim is recommended for safe printing.
v2 Update: It's a very small difference, but I made the inner diameter a bit tighter. When charging, the PLA print may miss the charger due to the heat.