1 / 6
Revesible stand for Youloop and K-480WLA loop antenna — zdjęcie 1
1 / 6

Revesible stand for Youloop and K-480WLA loop antenna

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This stand is reversible to fit both antennas

Ocena
0 / 5
Polubienia
1
Pobrania
42
Wydruki
0
Wyświetlenia
406
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

You will need about 1.4m of 20mm plastic conduit cut to the following lengths (cut a bit longer and adjust as neccesary):

  • 1x 280mm and 1x 165mm for the two bottom spoke pieces
  • 3x 280mm for the top and side spokes if you want it to be reversible, or
  • 3x 300mm for the top and side spokes if you just want to use it for one antenna

You will also need 1x 4 way conduit box and lid for the centre. I tried a 3D printed shape but with 4 large holes it's too difficult to print.

Then you need to print the following pieces:

  • 1x Hama Tripod Bracket (if you have a similar Hama tripod), or
  • 1x Base (to screw to a wooden base for example)
  • 1x Offset Bracket for the bottom spoke
  • 1x Youloop Antenna End Caps (contains 3 pieces, 1x top end cap and 2x side end caps), and/or
  • 1x K-480WLA Loop Antenna End Caps (contains 3 pieces, all the same)

Use an O-ring or an elastic band to secure the Youloop T-piece to the bottom spoke, and PVC glue to glue the end caps. Supports are required for the end caps and offset bracket.