1 / 6
Revesible stand for Youloop and K-480WLA loop antenna
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This stand is reversible to fit both antennas
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 42
- Makes
- 0
- Views
- 414
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
You will need about 1.4m of 20mm plastic conduit cut to the following lengths (cut a bit longer and adjust as neccesary):
- 1x 280mm and 1x 165mm for the two bottom spoke pieces
- 3x 280mm for the top and side spokes if you want it to be reversible, or
- 3x 300mm for the top and side spokes if you just want to use it for one antenna
You will also need 1x 4 way conduit box and lid for the centre. I tried a 3D printed shape but with 4 large holes it's too difficult to print.
Then you need to print the following pieces:
- 1x Hama Tripod Bracket (if you have a similar Hama tripod), or
- 1x Base (to screw to a wooden base for example)
- 1x Offset Bracket for the bottom spoke
- 1x Youloop Antenna End Caps (contains 3 pieces, 1x top end cap and 2x side end caps), and/or
- 1x K-480WLA Loop Antenna End Caps (contains 3 pieces, all the same)
Use an O-ring or an elastic band to secure the Youloop T-piece to the bottom spoke, and PVC glue to glue the end caps. Supports are required for the end caps and offset bracket.