1 / 3
Fan Blade/Spindle and Brackets for NEMA17 Pancake Stepper Motor — zdjęcie 1
1 / 3

Fan Blade/Spindle and Brackets for NEMA17 Pancake Stepper Motor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Parts to mount an experimental fan blade assembly to a 1 amp NEMA17 pancake stepper motor and thereafter to a breadboard

Ocena
0 / 5
Polubienia
2
Pobrania
26
Wydruki
0
Wyświetlenia
225
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Mounting bracket designs are included for both horizontal and vertical mounting of the propeller/fan assembly to the breadboard which also holds the Arduino UNO R3 board and associated electronics. Print the fan blades vertical and trim the tabs using dykes after printing close to the base of the blade. If you sand the trimmed area just right the blades should self-hold in the correct position while you Loctite the blades within the spindle. The spindle should fit the 5mm keyed motor shaft as printed. Likewise the hole for the 10-24 set screw should be sized right as printed. That hole will be slightly oval as you print it standing up. That said it is optional to run a No. 25 .149" drill thru it before tapping for a better tapping result. Be sure to run the tap deep enough for a fully tapped hole. The blades can be assembled with the fat edge leading or trailing. BTW I never print PLA anymore since the superior PETG filament, at least currently, has no cost penalty.

Tagi