1 / 2
Stone holder for small oil stones from Norton & Harbor Freight — zdjęcie 1
1 / 2

Stone holder for small oil stones from Norton & Harbor Freight

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Sharpening stone holder for the small combination Norton and Harbor Freight sharpening stones.

Ocena
0 / 5
Polubienia
3
Pobrania
24
Wydruki
0
Wyświetlenia
119
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

This stone holder acts as a holder for the stone when sharpening as well as being a storage case. Using this case will also reduce the chance of your stones getting chipped. In addition, keeping the stone in a case will prevent the oil from your stone staining surfaces where the stone is stored.  

Recommendations

  • Add rubber feet to prevent the stone holder from sliding when sharpening. 
  • Glue a piece of leather to the top and add some stropping compound to turn this into a complete sharpening system.
  • When glueing the leather attach it on one end as shown in the pictures so it can be used to deburr gouges.  

Printing Tips

  • There are two build plates. One of the Harbor Fright stone and another for the Norton 6x2 oil stone. You only need to print the plate you need for your stone. 
  • I recommend printing this in PETG as it is more resistant to the oil used when sharpening.
  • The models consist of large, thin and flat surfaces which can curl. The models are set to print with brim ears to reduce the chance of curling at the corners. If you experience curling I recommend drying the filament, cleaning the build plate and using a full brim. 

Tagi