2 Stage Rocket (D12 Size Engine)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A model rocket design that uses series staging with an estimated apogee of 2400 meters.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 239
- Wydruki
- 1
- Wyświetlenia
- 1144
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Hello, this is my first attempt at a 3d printed two-stage model rocket. I plan to work on learning about series and parallel staging to enhance my rocketry knowledge. To construct the rocket once printed you will need two D12 rocket engines, a shock cord, parachute, and wadding. Tie the shock cord to the interior mount and the nose cone. Wrap the parachute to the nose cone. Lastly, place the motors in and attach the booster to the main body. If you don't want to use the booster, you can just not print it and the rocket should work fine. You can launch the rocket off of any standard estes
Print setting:
Printer - Raise3d E2
Material - Polymaker Polyterra
Layer Height- 0.2
Raft/Brim: None
Infil: 10%