Filament sensor relocater + Y-Splitter in once for Anycubic Kobra S1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I found the relocator of SPEKERDUDE and the Y-splitter of InterlinkKnight and put them together
- Ocena
- 5 / 5
- Polubienia
- 92
- Pobrania
- 733
- Wydruki
- 4
- Wyświetlenia
- 3197
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I found the relocator of SPEKERDUDE but not the Y-splitter he used. So I found the Y-splitter of InterlinkKnight and put them together for my Anycubic Kobra S1.
You will need three PC4-M10 fittings and two screws M2,5 x 4 mm. If you could not find such screws, search them in a screw terminal connector.
I printed it with PETG and a layer hight of 0,2 mm.
Just a little note:
I printed without supports for the tubes, as no support structure interfaces are printed there anyway. It might help if you try to scrape away the unevenness inside the Y-piece with the tip of a very sturdy (but slightly flexible) metal rod. Of course, I printed supports under the ends of the Y-piece.
I used the M2.5x4 mm screws for the upper piece and I used the original screws for the sensor.
Thanks to SPEKERDUDE and InterlinkKnight.
Have fun with it.
Markus