1 / 2
Stop-Go Remote for SWI Trak Mills and Lathes — zdjęcie 1
1 / 2

Stop-Go Remote for SWI Trak Mills and Lathes

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A basic imitation of the Prototrak Stop/Go remotes

Ocena
0 / 5
Polubienia
1
Pobrania
7
Wydruki
0
Wyświetlenia
38
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Creative Commons — Attribution

Printed with extra walls (>3) and then tapped on one end to receive a pg7 cable gland (M12-1.5)

https://www.amazon.com/Lantee-Cable-Gland-Waterproof-Connector/dp/B0736VHP1X?source=ps-sl-shoppingads-lpcontext&ref_=fplfs&smid=A34GY1TQBRNLLB&gQT=2&th=1

 and a momentary push button on the other (M12-1.0).

https://www.mouser.com/ProductDetail/E-Switch/PS1040ARED?qs=QtyuwXswaQhZXpCvW9E%252B6w%3D%3D&srsltid=AfmBOooKmjQhuxKcgXdhQ_mhz-ZK_-d9Zk_9J7PJdr6xPqgFnJgusj4F

In this photo, I hadn't threaded the button in to “Part A” yet.  It will sit near-flush with the collar when threaded in.

I used a height range modifier to add ‘fuzzy skin’ to the grip part.  

The collar fits well enough that I may not bother to glue it in place, though that was the original intent.

Tagi