Prusa Core One Drybox upgrade

5 of six walls are already there, lets add one more.

Dont forget to seal the corners an the hole on the printers frame.
Silicone should be a good choice.

Also available: 

-a ring to stick a led strip on. For lighting the spool from behind. Uses 3 of the same magnets. NOTE: it does prohibit the use of wider spools, like e.g. the bambu spools

-Silica gel container. Uses 5 of the same magnets.

Order of installation:
1. Press the frame together
2. Press in Magnets  (use a dab of glue)
3. Insert square nuts
4. Install connectors and corners on one side of the frame (do not tighten bolts at this point; use correct position)
5. Insert Plexiglass
6. Install the rest of the connectors and corners
7. Tighten bolts
8. Install seal on surface over the bolt heads.
9. Install pivotpoints on the printer using the 3 existing rivet holes. Secure bolts with locking nuta. Needle nose pliers recommended.
10. Connect door to pivots using the M3x30 bolts. No nut needed, if inserted from the top

Material:
Seal: 10mm width, 6mm thickness (easily compressible) e.g.  https://de.aliexpress.com/item/1005008002213187.html?gatewayAdapt=glo2deu
M3x6 28x
M3x10 3x
M3 locking nut 3x
M3 square nut 28x
M3x30 3x
Plexiglass e.g. 300x300x3mm https://www.ebay.de/itm/365443565666?var=635242369327&_trksid=p4375194.c101949.m162918
Neodym Magnets round 10x3mm 12x