Clip-on screen mount adaptor for Qidi Plus 4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple clip-on screen mount adaptor for Qidi Plus 4
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 583
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A strong clip-into-place screen mounting adaptor plate for the Qidi Plus 4
This model will slide and clip onto the Qidi Plus 4 making use of the existing Plus 4's stock screen mounting holes.
Three mounting holes sized for M4 bolts (see attached diagram for dimensions) are provided for bolting your own screen mount hardware to the adaptor plate. I printed my own case to hold a Raspberry Touch Display 2 with a Pi3B+ attached to the screen, and bolted that to the mounting adaptor plate to provide a KlipperScreen display for the Plus 4 (see photos).
There are insertion slots for 3 of M4 square nuts to provide strong mounting points for anything that attaches to the bracket.
The bracket is angled at the same angle as the Plus4 bezel, and also provides a flat supporting beam to allow for additional weight to be borne without needing to support all the weight just on the clips alone.
The mounting bracket should be positioned in the orientation shown for best results.
Due to the internal case temperatures that can be achieved on the Plus 4, this bracket is best printed in anything that is tolerant of at least 75C temperatures before softening, which means no PLA or PETG. A 0.2mm layer height with 3 walls and a 15% infill volume should work fine for most situations.