Ender 3 v3 CoreXZ Toolhead Cover Mod for 40mm Hotend fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modification of toolhead cover so a 40mm fan can be used in place of the 25mm axial fan for the hotend
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 530
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Quick and dirty, emphasis on dirty, mount for a 40mm replacement to the tiny hotend fan. I used the Noctua 24v; it's PWM but it runs at full speed when there is no PWM signal. The fan comes with what you need to splice the existing axial fan connector, but I didn't have much luck with those so I soldered it.
Don't make any destructive changes until you've printed this out and tested the fit, as it is a bit tight. I tried to improve things (after what you see pictured), but there's always the chance the tweaks made it worse! :D
So far it has been solid. I expect that issues could show up in a hotter environment, long prints with TPU. That said, I've not noticed issues over the last month or so. I might, eventually, wire the 2-pin connector directly to the fan so there's no excess, but it does not cause problems as is.
Should also work with the v3 Plus.
I printed in PETG since it seats right up against the radiator, but in previous testing with PLA I did not notice issues
Attach fan with 12mm M3 socket head screws