1 / 2
Ender 3 v3 CoreXZ Toolhead Cover Mod for 40mm Hotend fan — image 1
1 / 2

Ender 3 v3 CoreXZ Toolhead Cover Mod for 40mm Hotend fan

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Modification of toolhead cover so a 40mm fan can be used in place of the 25mm axial fan for the hotend

Rating
0 / 5
Likes
9
Downloads
38
Makes
0
Views
530
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Quick and dirty, emphasis on dirty, mount for a 40mm replacement to the tiny hotend fan. I used the Noctua 24v; it's PWM but it runs at full speed when there is no PWM signal. The fan comes with what you need to splice the existing axial fan connector, but I didn't have much luck with those so I soldered it. 

Don't make any destructive changes until you've printed this out and tested the fit, as it is a bit tight. I tried to improve things (after what you see pictured), but there's always the chance the tweaks made it worse! :D

So far it has been solid. I expect that issues could show up in a hotter environment, long prints with TPU. That said, I've not noticed issues over the last month or so. I might, eventually, wire the 2-pin connector directly to the fan so there's no excess, but it does not cause problems as is. 

Should also work with the v3 Plus.

I printed in PETG since it seats right up against the radiator, but in previous testing with PLA I did not notice issues

Attach fan with 12mm M3 socket head screws