40k Magnet holder for base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a holder I made to hold 1/4" x 1/8" x 1/32" magnets purchased from K&J Magnetics.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 153
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Miniature Gaming Accessories
- Licencja
- Creative Commons — Public Domain
I created a circular disc with a small space to hold a magnet to glue under 40k models in FreeCAD. The magnets I used were these from the K&J Magnetics website.
https://www.kjmagnetics.com/b4201-neodymium-block-magnet?cat=39
I used gorilla glue brand superglue first to glue the magnets in and after to glue the plastic disc to the miniatures and I HIGHLY recommend printing off a pair of plastic tweezers. I used the largest one from below.
https://www.printables.com/model/205249-tweezers
For metal I cut steel plate from Ace hardware which I cut with 24 gauge cutters. Even with those it was a bit of a pain to cut the steel and it didn't come out completely straight. A rotary cutter is probably the correct tool to use.
I tried using elmers glue to attach the steel plate to plastic, which apparently makes steel rust like crazy so don't do that. In the end I super glued the steel to the plastic, and roughed up the plastic a bit with sandpaper to help the two surfaces stick.