Speedybee Mario 5 - Walksnail moonlight double antena mount

This is model of antenna mount for Walksnail Moonlight - designated for Speedybee Mario 5 drone frame.

Question :Why there is no place for GPS at the end of the antenna mount ? 

Answer: For better load distribution and better GPS signal reception.

Solution : install GPS module in the front (27 satelites in less than one minute).

You will need :

-TPU,

-2x small zip tie,

-XT60 E M socket as on photos,

-2x screw M2,5x20mm for socket assembly,

-2x nut M2,5 (both holes should tight enough if you dont want to use nuts),

Instruction:

-print antenna mount,

-use scissors to cut openings between legs (for easier assembly),

-solder wires between ESC and XT60 EM socket,

-install two antennas for VTX inside printed antenna mount,

- assemble  antena mount & XT60 EM socket on the drone frame,

- tight zip ties around antennas to hold it better in antenna mount, 

-fly like champion :)

Print parameters :

-bed temp 40 *C

-extruder temp 228 *C

-infill 15%

-wall line count 3 lines,

-print time about 50 minutes